How to select serial cable in gns3 free12/31/2022 ![]() ![]() Pinging from Windows 10 machine will succeed as follows. The output of show ip route command on R2 is as follows.Īfter EIGRP settings, ping each other to test the network connection between the virtual machines again, and test the connection between the two networks. ![]() Run the show ip route command on R1 and you can see that the EIGRP Routing protocol is enabled. R1(config-router)#network 192.168.5.0 0.0.0.255Īt the R2 CLI command prompt, also execute the following commands. It is important to note that the Wild Card Mask used when defining networks in the EIGRP protocol. To communicate two different networks with the EIGRP routing protocol, open the R1 CLI prompt and perform the following commands. Select VMnet1 for the network card of the Windows 8.1 virtual machine and run the virtual machine.Ĭonfigure VMnet2 as the Windows 10 virtual machine network card.Īfter configuring the Windows 8.1 machine TCP/IP settings, test the connection by pinging the Router FastEthernet 0/0 and Serial 0/0 interfaces.Īlso, before configuring EIGRP, check the connection by pinging the Router R2 interfaces and check that the Ping operation failed. R2(config-if)#ip address 10.1.1.2 255.255.255.252Īfter you run the virtual machines, you must configure the VMnet settings. *Mar 1 00:02:08.995: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up ![]() *Mar 1 00:02:07.995: %LINK-3-UPDOWN: Interface FastEthernet0/1, changed state to up R1(config-if)#ip address 10.1.1.1 255.255.255.252Ĭonfigure the Router R2 interfaces in the same way. *Mar 1 00:00:44.715: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up *Mar 1 00:00:43.715: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up R1#conf tĮnter configuration commands, one per line. Then power on the Routers, and open the CLI prompts.Ĭonfigure the Cisco Router R1 interfaces with the following commands. Run the GNS3 network simulator software and then create a new project.įirst, create a network topology for EIGRP as in the image below. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |